Agilent Technologies 1260 User Manual page 51

1 Note the MAC address of the LAN interface (rear of the module, under the
2 Place the module in the stack or on the bench in a horizontal position.
3 Ensure the line power switch at the front of the module is OFF.
4 Connect the power cable to the power connector at the rear of the module.
5 Connect the CAN cable to other Agilent 1200 Series modules.
6 Connect the LAN cable (e.g. from a Agilent ChemStation as controller) to
In multi-detector configurations the LAN of the G1315C/D and G1365C/D must be used
N O T E
due to its higher data load.
7 Connect the analog cable(s) (optional).
8 Connect the APG remote cable (optional) for non-Agilent 1200 Series
Agilent 1260 Infinity DAD and MWD User Manual
configuration switch, see
Configuration" on page 57.
Figure 10 Rear View of Detector
the detector's LAN connector.
instruments.
Figure 10 on page 51). It's required for
Installing the Module
Installing the Detector
"LAN
3
51