Ftp Client Source - H3C S5120-EI Series Command Reference Manual

service-port: TCP port number of the remote FTP server, in the range 0 to 65535. The default value is 21.
source { interface interface-type interface-number | ip source-ip-address } ]: Specifies the source address
used to establish an FTP connection.
interface interface-type interface-number: Specifies the source interface by its type and number. The
•
primary IP address configured on this interface is the source address of the transmitted FTP packets.
If no primary IP address is configured on the source interface, the connection fails.
• ip source-ip-address: The source IP address of the transmitted FTP packets. This source address must
be the one that has been configured on the device.
Description
Use the ftp command to log in to the remote FTP server and enter FTP client view.
NOTE:
• This command applies to IPv4 networks.
If you use this command without specifying any parameters, you will simply enter the FTP client view
•
without logging in to the FTP server.
If you specify the parameters, you will be prompted to enter the username and password for accessing
•
the FTP server.
Examples
# Log in from the current device Sysname1 to the device Sysname2 with the IP address of 192.168.0.21 1.
The source IP address of the packets sent is 192.168.0.212.
<Sysname> ftp 192.168.0.211 source ip 192.168.0.212
Trying 192.168.0.211 ...
Press CTRL+K to abort
Connected to 192.168.0.211.
220 FTP Server ready.
User(192.168.0.211:(none)):abc
331 Password required for abc
Password:
230 User logged in.
[ftp]

ftp client source

Syntax
ftp client source { interface interface-type interface-number | ip source-ip-address }
undo ftp client source
View
System view
Default level
2: System level
60