Voip Interfaces For Combined Application Types - AudioCodes Mediant 1000B User Manual

Destination
176.85.49.0
3. All other parameters are set to their respective default values. The NTP application
remains with its default application types.

12.5.3.3 VoIP Interfaces for Combined Application Types

This example describes the configuration of multiple interfaces for the following
applications:

One interface for the OAMP application.

Interfaces for Call Control and Media applications, where two of them are IPv4
interfaces and one is an IPv6 interface.
1. IP Interfaces table:
Table 12-10: Example of VoIP Interfaces of Combined Application Types in IP Interfaces table
Inde Applicatio Interfac
x n Type e Mode
0 OAMP IPv4
Manual
1 Media & IPv4
Control Manual
2 Media & IPv4
Control Manual
3 Media & IPv6
Control Manual
2. Static Routes table: A routing rule is required to allow remote management from a
host in 176.85.49.0/24:
Destination
176.85.49.0
3. The NTP application is configured (through the ini file) to serve as OAMP applications:
EnableNTPasOAM = 1
4. DiffServ table:
•
Layer-2 QoS values are assigned:
♦
♦
♦
♦
•
Layer-3 QoS values are assigned:
♦
♦
User's Manual
Prefix Length
IP Address
192.168.0.2
200.200.85.14
200.200.86.14
2000::1:200:200:86:1
4
Table 12-11: Example of Static Routes Table
Prefix Length
For packets sent with DiffServ value of 46, set VLAN priority to 6
For packets sent with DiffServ value of 40, set VLAN priority to 6
For packets sent with DiffServ value of 26, set VLAN priority to 4
For packets sent with DiffServ value of 10, set VLAN priority to 2
For Media Service class, the default DiffServ value is set to 46
For Control Service class, the default DiffServ value is set to 40
Mediant 1000B Gateway & E-SBC
24
Prefix
Default
Lengt
Gateway
h
16 192.168.0.1
24 200.200.85.
1
24 200.200.86.
1
64 ::
24
148
Gateway
192.168.11.1
Etherne
t Name
Device
1 Mgmt
201 MediaCntrl1
202 MediaCntrl2
202 V6CntrlMedia
2
Gateway
192.168.0.10
Document #: LTRT-27055