Networking Configuration Examples; One Voip Interface For All Applications; Voip Interface Per Application Type - AudioCodes Mediant 800B User Manual

Gateway & enterprise sbc (e-sbc)

Hide thumbs Also See for Mediant 800B:

Table of Contents

User's Manual

For IPv4 addresses, the 'Interface Mode' column must be set to IPv4 Manual. For IPv6

addresses, this column must be set to IPv6 Manual or IPv6 Manual Prefix.

comprehensive validation tests. If any errors occur during this validation phase, the

device sends an error message to the Syslog server and falls back to a "safe mode",

using a single interface without VLANs. Ensure that you view the Syslog messages

that the device sends in system startup to see if any errors occurred.

12.5.3 Networking Configuration Examples

This section provides configuration examples of networking interfaces.

This example describes the configuration of a single VoIP interface for all applications:

IP Interfaces table: Configured with a single interface for OAMP, Media and Control:

Table 12-6: Example of Single VoIP Interface in IP Interfaces table

Static Routes table: Two routes are configured for directing traffic for subnet

201.201.0.0/16 to 192.168.11.10, and all traffic for subnet 202.202.0.0/16 to

192.168.11.1:

The NTP applications remain with their default application types.

This example describes the configuration of three VoIP interfaces - one for each

application type:

IP Interfaces table: Configured with three interfaces, each for a different application

type, i.e., one for OAMP, one for Call Control, and one for RTP Media, and each with

a different VLAN ID and default gateway:

Table 12-8: Example of VoIP Interfaces per Application Type in IP Interfaces table

Upon device start up, the IP Interfaces table is parsed and passes

Table 12-7: Example of Static Routes Table

Prefix Length

Mediant 800B Gateway & E-SBC

192.168.11.10

192.168.11.1