Table 8-5: Mlpp Call Priority Levels (Precedence) And Dscp Configuration Parameters; Multilevel Precedence And Preemption - AudioCodes Mediant 600 User Manual


3WayConferenceMode (conference mode)

FlashKeysSequenceStyle = 1 or 2 (makes a three-way call conference using the Flash
button + 3)

8.3.9.10 Multilevel Precedence and Preemption

The device's Multilevel Precedence and Preemption (MLPP) service can be enabled using
the CallPriorityMode parameter. MLPP is a call priority scheme, which does the following:

Assigns a precedence level (priority level of call) to specific phone calls or messages.

Allows higher priority calls (precedence call) and messages to preempt lower priority
calls and messages (i.e., terminates existing lower priority calls) that are recognized
within a user-defined domain (MLPP domain ID). The domain specifies the collection
of devices and resources that are associated with an MLPP subscriber. When an
MLPP subscriber that belongs to a particular domain places a precedence call to
another MLPP subscriber that belongs to the same domain, MLPP service can
preempt the existing call that the called MLPP subscriber is on for a higher-
precedence call. MLPP service availability does not go across different domains
MLPP is typically used in the military where for example, high-ranking personnel can
preempt active calls during network stress scenarios, such as a national emergency or
degraded network situations.
The Resource Priority value in the Resource-Priority SIP header can be any on of those
listed in the table below. A default MLPP call Precedence Level (configured by the
SIPDefaultCallPriority parameter) is used if the incoming SIP INVITE or PRI Setup
message contains an invalid priority or Precedence Level value respectively. For each
MLPP call priority level, the Multiple Differentiated Services Code Points (DSCP) can be
set to a value from 0 to 63.

Table 8-5: MLPP Call Priority Levels (Precedence) and DSCP Configuration Parameters

MLPP Precedence Level
0 (lowest)
2
4
6
8
9 (highest)

Precedence Ring Tone: You can assign a ring tone (in the CPT file) that is played
when a Precedence call is received from the IP side. This is configured by the
parameter PrecedenceRingingType. In addition, you can define (using the
PreemptionToneDuration parameter) the duration for which the device plays a
preemption tone to the Tel and IP sides if a call is preempted.

Emergency Telecommunications Services calls (e.g., E911): ETS calls can be
configured to be regarded as having a higher priority than any MLPP call (default),
using the E911MLPPBehavior parameter.

MLPP Preemption Events in SIP Reason Header: The device sends the SIP
Reason header (as defined in RFC 4411) to indicate the reason a preemption event
occurred and the type of preemption event. The device sends a SIP BYE or CANCEL
request, or 480, 486, 488 responses (as appropriate) with a Reason header whose
Reason-params can includes one of the following preemption cause classes:
•
Reason: preemption ;cause=1 ;text="UA Preemption"
SIP User's Manual
Precedence Level in Resource-
Priority SIP Header
routine
priority
immediate
flash
flash-override
flash-override-override
338
Mediant 600 & Mediant 1000
DSCP Configuration Parameter
MLPPRoutineRTPDSCP
MLPPPriorityRTPDSCP
MLPPImmediateRTPDSCP
MLPPFlashRTPDSCP
MLPPFlashOverRTPDSCP
MLPPFlashOverOverRTPDSCP
Document #: LTRT-83308