Create Myconfig - Ncushare; Introduction; Ncushareservice; Installation - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - NcuShare

7.1

Introduction

7.1.1

NcuShareService

An exchange release is required for processing Windows packages with NCU share. The
previous configuration of the exchange release is replaced with the NcuShareService
"Create MyConfig NcuShare".
A setup is available for the installation of the service.
7.2

Installation

7.2.1 Installation
There are three possible options for installing the service "Create MyConfig NcuShare".
1. Installation with the setup of Create MyConfig
2. Manual installation by executing NcuShareServiceSetup.msi
After installing Create MyConfig, the setup file is available in the installation folder under /
Shield.
3. Installation for package execution. (Reference to Expert)
When the service is installed, a folder can be configured for the installation types 1 and 2,
which is used as the
exchange folder.
7.2.2

"Create MyConfig NcuShare" service

The service is installed during the installation on the Windows computer under the program
name "Create MyConfig NcuShareService" with the specified service version and entered
under the name "Create MyConfig NcuShare" in the list of services.
The service is in the service status "Finished" after installation.
The service is started with the execution of Windows packages with NCU share for the duration
of the package execution and is then closed again.
When the service is started, it automatically activates the exchange release for the NCU
access.
This permits the exchange of data between NCU and PC/PCU during package execution.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
7
417