Siemens SINUMERIK 840D sl Operating Manual page 228

Create MyConfig - Expert
4.5 Component editor
Copying in the data management (HMI-Adv, archive)
For folders and files in data management, names with characters: A-Z_0-9 and a maximum
length of 24 characters are permissible.
Further, especially folders are subject to the data management conventions regarding their
names.
The following options are available when copying in the data management:
HMI-Adv/DH
Archive/NC
Archive/MMC
Archive/NC_MMC
The sequence when executing is fixed:
228
Copies to the PCU in the F:\DH folder and at the same time adapts the
necessary entries in HMI-Advanced data management (saved in the files:
__dhinf.000).
This is the preferred procedure for transferring large data volumes (bmp,
pdf, hlp, etc.) to the control system.
Note:
When files are copied, files with the same name in Archive/NC or Archive/
MMC are deleted.
Copies to the NC area of the archive. When the archive is loaded, all the
data contained therein is transferred directly to the NC.
Note:
When files are copied, files with the same name in Archive/MMC or
HMI-Adv/DH are deleted.
Copies to the MMC area of the archive. When the archive is loaded, all
the data contained therein is transferred directly to the HMI (MMC).
Using archive/NC_MMC, the functionality of an MMC archive can be im‐
plemented to replace data where it was already located.
Note:
When files are copied, files with the same name in archive/NC or
HMI-Adv/DH are deleted.
Copies to the NC area of the archive if the file is already available there.
Otherwise the file is copied to the MMC area. Regarding loading the ar‐
chive, the statements made above apply.
Note:
When files are copied, files with the same name in archive/NC, archive/
MMC or HMI-Adv/DH.
HMI-Adv/DH → Archive/NC → Archive/MMC → Archive/NC_MMC
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD