Changes To System Variables - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.2 Introduction
Querying SINAMICS drive parameters
Syntax Version 2.6
Not directly possible
Sections in tasks of SINAMICS data
The sections in tasks of SINAMICS data are converted from the long notation still tolerated in
SCI into a new shorthand notation, if the section does not contain a replacement operator.
Syntax Version 2.6
[BUS3.DIR/SLAVE3.DIR/
PS000099.ACX]
4.2.4.3

Changes to system variables

Note
Changes in the case of system variables
In the case of Create MyConfig, Version V4.7 SP2 or higher, there have been changes to the
system variables for the NCU/PPU initial state and system configuration dialogs.
Take note of the following section.
New NCU/PPU initial state dialog
The "Data backup of CF card" function has been removed from the "NCU/PPU access" dialog
page and moved to the new "NCU/PPU initial state" dialog page. As a result, after execution
of the "NCU/PPU access" dialog page using script based on the determined software release,
a decision can be made as to whether it is necessary to execute the "NCU/PPU initial state"
(Backup) dialog page.
The system variables involved have changed; however, they are still accepted in configuration
files. In scripts, an error message is issued in the compilation run and an adjustment must be
made.
Up.$Dialog.NcuAccess.Backup
Up.$Dialog.NcuAccess.Archive
System configuration dialog
The "Use data" property in the "System configuration" dialog has been removed.
Thus, the "Use data" configuration in the "System configuration" dialog for the NC, PLC and
DRV control area is no longer possible.
104
Conversion possible?
-
Conversion possible?
Partially:
Only if a replacement operator is not
contained.
Syntax as of Version 4.6:
PS[B3_S3_PS1].p105
Syntax as of Version 4.6:
[B3_S3_PS99]
→ Up.$Dialog.NcuOrigin.Backup
→ Up.$Dialog.NcuOrigin.Archive
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD