Operating Page; Single Input Conductivity - ABB AX410 User Manual

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456

2.3 Operating Page

2.3.1 Single Input Conductivity

0. 8 83
uS/cm
24. 8
Deg.C
Conductivity
0. 8 83
uS/cm
----
Manual
Control Mode
0. 8 83
uS/cm
60. 0
% Man.
Setpoint 90.0
1. 0 00
uS/cm
150. 0
%Sat
Control Setpoint
0. 8 86
uS/cm
@ 25 Deg.C
Conductivity
6
Measured Values
Conductivity.
Temperature.
Notes.
• The displayed conductivity and temperature readings are the actual measured
values of the sample.
• AX450 analyzers only - if
displayed conductivity reading is the uncompensated conductivity value of the
sample, i.e. its value at the displayed temperature.
Control Mode
Conductivity value.
Control mode.
Use the and
control.
Note. Displayed only if
Control Output
Conductivity value.
Control output (%), manual (
When
Control Mode
adjust the control output between 0 and 100%.
Note. Displayed only if
Control Set Point
Conductivity value.
Control set point.
Use the and
conductivity.
Note. Displayed only if
Temperature Compensated Conductivity Value - AX450 Analyzers Only
Notes.
• This frame is displayed only if
page 21.
• The displayed reading is the temperature compensated conductivity value i.e. the
value it would be at a sample temperature of 25ºC (77ºF).
See Section 3.1.
VIEW SETPOINTS
set to
Enable Cals.
SENSOR CAL.
set to
Enable Cals.
SECURITY CODE
see section 5.1, page 19.
set to
Enable Cals.
CONFIG. DISPLAY
section 5.2, page 20.
is set to
A: Cond.Units
keys to switch between manual (
is set to - see section 5.7, page 41.
Controller PID
) or automatic (
Man
is set to (see above), use the
Manual
is set to - see section 5.7, page 41.
Controller PID
keys to adjust the control set point between 0 and 250%
is set to - see section 5.7, page 41.
Controller PID
A: Cond.Units
(Section 5.3) - see section 4.1, page 17.
Yes
(Section 5.3) and
No Alter Sec. Code
(Section 5.3) and
No Alter Sec. Code
2 OPERATION
(Section 5.3), the
USP645
) and automatic (
Manual
).
Auto
and keys to
is set to - see section 5.3,
USP645
not set to zero (Section 5.9) -
set to zero (Section 5.9) - see
IM/AX4CO
)
Auto
Issue 11