Table of Contents
Advertisement
RUGGEDCOM ROS
User Guide
Parameter
4.
Click Apply.
Section 5.4.13
Configuring the DNP Over Raw Socket Protocol
To configure the DNP Over Raw Socket protocol for a serial port, do the following:
1.
Make sure the serial port is configured to use the DNP Over Raw Socket protocol. For more information, refer
to
Section 5.4.5, "Configuring a Serial Port"
2.
Navigate to Serial Protocols » Configure Protocols » Configure DNP Protocol » Configure DNP over
RawSocket . The DNP over RawSocket table appears.
Figure 95: DNP over RawSocket Table
3.
Select a serial port. The DNP over RawSocket form appears.
Configuring the DNP Over Raw Socket Protocol
Description
sent to the subnet of the address configured for learning and
source addresses will be learned. If local address is not known,
message will be sent to all serial ports running DNP protocol.
Local addresses will be learned from local responses. If TCP
transport is configured, connection will be established to the
devices with the corresponding IP address.
.
Chapter 5
Setup and Configuration
155
Advertisement
Table of Contents
