RUGGEDCOM ROS
User Guide
Figure 106: Device Address Table Table
If device addresses have not been configured, add addresses as needed. For more information, refer to
Section 5.4.17.2, "Adding a Device Address"
Section 5.4.17.2
Adding a Device Address
To add a device address, do the following:
1.
Navigate to Serial Protocols » Configure Device Addresses . The Device Address Table table appears.
1
Figure 107: Device Address Table Table
1. InsertRecord
2.
Click InsertRecord. The Device Address Table form appears.
Adding a Device Address
.
Chapter 5
Setup and Configuration
165