Table of Contents
Advertisement
Chapter 5
Setup and Configuration
•
Section 5.4.16.3, "Deleting a Remote Host"
Section 5.4.16.1
Viewing a List of Remote Hosts
To view a list of remote hosts configured for the Raw socket protocol, navigate to Serial Protocols » Configure
Protocols » Configure Raw Socket » Configure Remote Hosts . The Remote table appears.
Figure 101: Remote Table
If remote hosts have not been configured, add hosts as needed. For more information, refer to
"Adding a Remote Host"
Section 5.4.16.2
Adding a Remote Host
To add a remote host for the Raw socket protocol, do the following:
Navigate to Serial Protocols » Configure Protocols » Configure Raw Socket » Configure Remote Hosts .
1.
The Remote Hosts table appears.
Figure 102: Remote Table
2.
Click InsertRecord. The Remote Hosts form appears.
162
.
RUGGEDCOM ROS
User Guide
Section 5.4.16.2,
Viewing a List of Remote Hosts
Advertisement
Table of Contents
