RUGGEDCOM ROS
User Guide
4
Figure 103: Remote Hosts Form
1. IP Address Box 2. IP Port Box 3. Port(s) Box 4. Apply Button 5. Delete Button 6. Reload Button
3.
Configure the following parameter(s) as required:
Parameter
IP Address
IP Port
Port(s)
4.
Click Apply.
Section 5.4.16.3
Deleting a Remote Host
To delete a remote host used by the Raw socket protocol, do the following:
Navigate to Serial Protocols » Configure Protocols » Configure Raw Socket » Configure Remote Hosts .
1.
The Remote table appears.
Deleting a Remote Host
5
Description
Synopsis: ###.###.###.### where ### ranges from 0 to 255
Default:
The IP address of the remote host.
Synopsis: 1 to 65535 or { Unknown }
Default: 50000
The IP port that remote host listens to. If this is zero (Unknown),
the unit only receives from the remote host but does not transmit
to it.
Synopsis: Any combination of numbers valid for this parameter
Default: All
The local serial ports that the remote host is allowed to
communicate with.
Chapter 5
Setup and Configuration
1
2
3
6
163