Table of Contents
Advertisement
RUGGEDCOM ROS
User Guide
Parameter
Flow Control
Response Time
Response Dest
Transport
Call Dir
Max Conns
Loc Port
Rem Port
IP Address
Link Stats
Configuring the Raw Socket Protocol
Description
Synopsis: { None, XON/XOFF }
Default: None
The Flowcontrol setting for serial port.
Synopsis: 50 to 60000 ms or { Off }
Default: Off
The maximum allowable time to wait for the response on serial
port.
Synopsis: { All, Last requester }
Default: All
The destination where data received from serial port will be sent.
If the value of Response Time is not 'Off', Response Dest will be
autmatically set to All when record is applied.
Synopsis: { TCP, UDP }
Default: TCP
The network transport used to transport protocol data over IP
network.
Synopsis: { In, Out, Both }
Default: In
The Call direction for TCP Tranport.
• Whether to accept an incoming connection or
• to place an outgoing connection or
• to place outgoing connection and wait for incomming (both
directions).
Synopsis: 1 to 64
Default: 1
The maximum number of allowed incoming TCP connections (for
configurations using TCP).
Synopsis: 1024 to 65535
Default: 50000
The local IP port to use when listening for an incoming connection
or UDP data.
Synopsis: 1 to 65535
Default: 50000
The remote TCP port to use when placing an outgoing
connection. Note that this parameter is applicable only to TCP
connections. If the transport protocol is set to UDP, the remote
port is configured using the "Remote Hosts" table.
Synopsis: ###.###.###.### where ### ranges from 0 to 255 or
{ }
For direction: 'Out' (client), the remote IP address to use when
placing an outgoing TCP connection request.
For direction: 'In' (server), the local interface IP address on which
to listen for connection requests. An empty string implies the
default: the IP address of the management interface.
For direction: 'Both' (client or server), the remote IP address to
use when placing an outgoing TCP connection request. The
listening interface will be chosen by matching mask. Note that
this parameter is applicable only to TCP connections. If the
transport protocol is set to UDP, the remote port is configured
using the "Remote Hosts" table.
Synopsis: { Disabled, Enabled }
Chapter 5
Setup and Configuration
145
Advertisement
Table of Contents
