Rapid Advance Feature - ALLIANCE HWNLX2SP111CW01 Manual

The Rapid Advance feature allows the owner to
quickly advance through active cycles or advance into
a cycle from the ready mode.
How to Enter Rapid Advance from
Ready Mode
1. If control is in Ready Mode, control must be put
into Manual Mode. Refer to Entering the
Manual Mode.
NOTE: For card reader models, remove the control
panel and unplug the bullet connector located
between the "white/black" and "red/blue" wires.
2. Press the DELICATES ( ) or the COLD ( )
keypad until "rAPd" appears in the display.
3. Press the START (enter) keypad. The display will
show "PUSH" then "Strt" followed by the cycle
time.
4. Press the START (enter) keypad to start cycle.
How to Enter Rapid Advance During
an Active Cycle
1. Be certain service door is open.
2. While pressing and holding the NORMAL
keypad with one hand, press the HOT keypad
with the other hand. "rAPd"appears in the
display.
3. Press the START (enter) keypad to advance the
cycle.
Control may be in an active cycle or in the ready mode
to use the Rapid Advance feature.
While in the Rapid Advance Mode, pressing the
START (enter) keypad will advance the washer to the
next cycle step. The cycle indicator lights will tell
which cycle step the washer is in.
For Example: If the washer is in the wash fill/agitate
cycle step, pressing the START (enter) keypad will
advance the washer into the WASH PAUSE cycle step.
Continue pressing the START (enter) keypad until the
cycle is completed.
96

Rapid Advance Feature

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
How to Exit Rapid Advance Feature
NOTE: For card reader models, be sure to
reconnect the bullet connector between the "white/
black" and "red/blue" wires.
1. Advance through the cycles until reaching the
ready mode.
NOTE: The Manual Rapid Advance option must
be turned on for Rapid Advance to work. Refer to
option 34 in Programming Control.
202065R6