ALLIANCE HWNLX2SP111CW01 Manual page 72

Programming Control
How to Program Heavy Cycle Selection
"
Option "CnP2
This option allows the owner to enable or disable the
Heavy Cycle Selection option.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Modifier options until "CnP2" appears in the
display.
2. When "CnP2" appears in the display, press the
START (enter) keypad. The current status will
appear in the display. "on" (factory default
setting) indicates the Heavy Cycle Selection
option is enabled. "oFF" indicates this option is
disabled.
3. Press the DELICATES ( ) or the COLD ( )
keypad to change the status.
4. Press the START (enter) keypad when the
desired status appears in the display. The next
Cycle Modifier option, "CnP3", will appear in
the display.
"
NOTE: To program CnP3
Selection Extra Wash Time), continue to next Cycle
Modifier option. To program other options, press
the WARM (<) keypad and refer to the appropriate
section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
70
"
(Heavy Cycle
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
How to Program Heavy Cycle Selection
Extra Wash Time "CnP3"
This option allows the owner to set the amount of
additional wash agitate time for the Heavy Cycle
Selection.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Modifier options until "CnP3" appears in the
display.
2. When "CnP3" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Heavy Cycle Selection Extra
Wash Time will appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes displayed in the display to the
desired number of minutes.
NOTE: The Heavy Cycle Selection Extra Wash
Time can be set from zero (0) to ten (10) minutes
The factory default setting is two (2).
4. Press the START (enter) keypad when the
desired number of minutes appears in the display.
The next Cycle Modifier option, "CnP4", will
appear in the display.
NOTE: The Heavy Cycle Selection option needs to
be turned on (refer to Heavy Cycle Selection
option) for the Heavy Cycle Selection Extra Wash
Time to take effect.
NOTE: To program "CnP4" (Heavy Cycle
Selection Extra Extra Rinse Time), continue to next
Cycle Modifier option. To program other options,
press the WARM (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
202065R6