ALLIANCE HWNLX2SP111CW01 Manual page 80

Programming Control
How to Program Delicate Rinse Agitate
Time "CP11"
This option allows the owner to set the amount of rinse
agitate time for the Delicate cycle.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Programming options until "CP11" appears in
the display.
2. When "CP11" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Delicate Rinse Agitate Time
will appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Delicate Rinse Agitate Time can be set
from zero (0) to ten (10) minutes. The factory
default setting is four (4).
4. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next Cycle Programming option, "CP12", will
appear in the display.
NOTE: To program "CP12" (Delicate Final Spin
Time), continue to next Cycle Programming option.
To program other options, press the WARM (<)
keypad and refer to the appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
78
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
How to Program Delicate Final Spin Time
"CP12"
This option allows the owner to set the amount of final
spin time for the Delicate cycle.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Programming options until "CP12" appears in
the display.
2. When "CP12" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Delicate Final Spin Time will
appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Delicate Final Spin Time can be set
from zero (0) to ten (10) minutes. The factory
default setting is five (5).
4. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next Cycle Programming option, "CP13", will
appear in the display.
NOTE: To program "CP13" (Warm Rinse
Option), continue to next Cycle Programming
option. To program other options, press the
WARM (<) keypad and refer to the appropriate
section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
202065R6