ALLIANCE HWNLX2SP111CW01 Manual page 77

How to Program Permanent Press Wash
Agitate Time "CP5"
This option allows the owner to set the amount of
wash agitate time for the Permanent Press cycle.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Programming options until "CP5" appears in the
display.
2. When "CP5" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Permanent Press Wash
Agitate Time will appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Permanent Press Wash Agitate Time
can be set from zero (0) to ten (10) minutes. The
factory default setting is ten (10).
4. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next Cycle Programming option, "CP6", will
appear in the display.
NOTE: To program "CP6" (Permanent Press
Extra Rinse Agitate Time), continue to next Cycle
Programming option. To program other options,
press the WARM (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
202065R6
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
How to Program Permanent Press Extra
Rinse Agitate Time "CP6"
This option allows the owner to set the amount of
extra rinse agitate time for the Permanent Press cycle.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Programming options until "CP6" appears in the
display.
2. When "CP6" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Permanent Press Extra Rinse
Agitate Time will appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Permanent Press Extra Rinse Agitate
Time can be set from zero (0) to ten (10) minutes.
The factory default setting is zero (0).
4. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next Cycle Programming option, "CP7", will
appear in the display.
NOTE: To program "CP7" (Permanent Press
Rinse Agitate Time), continue to next Cycle
Programming option. To program other options,
press the WARM (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
Programming Control
75