Cycle Programming "Cp - ALLIANCE HWNLX2SP111CW01 Manual

26. Cycle Programming "CP--"

This option allows the owner to set the amount of time
for various steps in each type of cycle.
How to Program Normal Wash Agitate
" "
Time CP1
This option allows the owner to set the amount of
wash agitate time for the Normal Cycle.
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES ( ) or the COLD ( )
keypad until "Prog" appears in the display. Press
the START (enter) keypad and "AtS1" will
appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable
options until "CP--" appears in the display. Press
the START (enter) keypad and "CP1" will
appear in the display.
4. When "CP1" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Normal Wash Agitate Time
will appear in the display.
5. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Normal Wash Agitate Time can be set
from zero (0) to ten (10) minutes. If the Normal
Wash Agitate Time is set to zero (0), the step is
skipped. The factory default setting is ten (10).
6. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next Cycle Programming option, "CP2", will
appear in the display.
NOTE: To program "CP2" (Normal Extra Rinse
Agitate Time), continue to next Cycle
Programming option. To program other options,
press the WARM (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
202065R6
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
How to Program Normal Extra Rinse
Agitate Time "CP2"
This option allows the owner to set the amount of
extra rinse agitate time for the Normal Cycle.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Programming options until "CP2" appears in the
display.
2. When "CP2" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Normal Extra Rinse Agitate
Time will appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Normal Extra Rinse Agitate Time can
be set from zero (0) to ten (10) minutes. The factory
default setting is zero (0).
4. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next Cycle Programming option, "CP3", will
appear in the display.
NOTE: To program "CP3" (Normal Rinse Agitate
Time), continue to next Cycle Programming option.
To program other options, press the WARM (<)
keypad and refer to the appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
Programming Control
73