ALLIANCE HWNLX2SP111CW01 Manual page 73

How to Program Heavy Cycle Selection
Extra Rinse Time "CnP4"
This option allows the owner to set the amount of
additional time for the extra rinse for the Heavy Cycle
Selection.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Modifier options until "CnP4" appears in the
display.
2. When "CnP4" appears in the display, press the
START (enter) keypad. The current number of
minutes set for the Heavy Cycle Selection Extra
Rinse Time will appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the current
number of minutes shown in the display to the
desired number of minutes.
NOTE: The Heavy Cycle Selection Extra Rinse
Time can be set from zero (0) to ten (10) minutes.
The factory default setting is zero (0).
4. Press the START (enter) keypad when the correct
number of minutes appears in the display. The
next option, "CnP5", will appear in the display.
NOTE: The Heavy Cycle Selection option needs to
be turned on (refer to Heavy Cycle Selection
option) for the Heavy Cycle Selection Extra Rinse
Time to take effect.
"
NOTE: To program CnP5
Selection Warm Rinse option), continue to next
Cycle Modifier option. To program other options,
press the WARM (<) keypad and refer to the
appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
202065R6
"
(Heavy Cycle
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
How to Program Heavy Cycle Selection
Warm Rinse Option "CnP5"
This option allows the owner to program an optional
warm fill temperature for the final rinse fill of the
Heavy Cycle Selection. If this option is enabled and
HOT or WARM water is selected for the wash fill,
warm water will be used for the final rinse fill.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable
options until "CnP5" appears in the display.
2. When "CnP5" appears in the display, press the
START (enter) keypad. The current Heavy Cycle
Selection Warm Rinse Option status will appear
in the display.
"on" = Option Enabled
"oFF" = Option Disabled
(factory default setting)
3. Press the DELICATES ( ) or the COLD ( )
keypad to change the current status.
4. Press the START (enter) keypad when the
desired status appears in the display. The next
Cycle Modifier option, "CnP1" (software
version "S 01") or "CnP6" (software version
"S 02" or higher), will appear in the display.
NOTE: For software version "S 01," to program
"CP--" (Cycle Programming), press the WARM (<)
keypad to return to the main programming options
list and refer to option 26. For software version "S
02" or higher, to program "CnP6" (Default Cycle
Modifier), continue to the next Cycle Modifier
option. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
Programming Control
71