Drop Off Mode (On/Off) "Drop - ALLIANCE HWNLX2SP111CW01 Manual

How to Program Warm Rinse Option
"CP13"
This option allows the owner to program an optional
warm fill temperature for the final rinse fill. If this
option is enabled and HOT or WARM water is
selected for the wash fill, warm water will be used for
the final rinse fill.
1. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable Cycle
Programming options until "CP13" appears in
the display.
2. When "CP13" appears in the display, press the
START (enter) keypad. The current Warm Rinse
Option status will appear in the display.
"on" = Option Enabled
"oFF" = Option Disabled
(factory default setting)
3. Press the DELICATES ( ) or the COLD ( )
keypad to change the current status.
4. Press the START (enter) keypad when the
desired status appears in the display. The next
Cycle Programming option, "CP1", will appear
in the display.
NOTE: To program "droP" (Drop Off Mode),
press the WARM (<) keypad and refer to option 27.
To program other options, refer to the appropriate
section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
202065R6
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

27. Drop Off Mode (On/Off) "droP"

This option allows the owner to limit machine use to
an attendant without requiring vend.
How to Program the Drop Off Mode (On/
Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES ( ) or the COLD ( )
keypad until "Prog" appears in the display. Press
the START (enter) keypad and "AtS1" will
appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable
options until "droP" appears in the display.
4. When "droP" appears in the display, press the
START (enter) keypad. The current Drop Off
Mode (On/Off) Status will appear in the display.
"on" = Option Enabled
"oFF" = Option Disabled
(factory default setting)
5. When the Drop Off Mode is enabled, starting the
machine requires the correct sequence of four
keypad presses. The default sequence
programmed at the factory is NORMAL, PERM
PRESS, DELICATE, CYCLE SELECT.
6. Press the DELICATES ( ) or the COLD ( )
keypad to change the current status.
7. Press the START (enter) keypad when the
desired status appears in the display. The next
option, "LPSA", will appear in the display.
NOTE: To program "LPSA" (Low Power/Auto
Shutdown A Days Enable), refer to option 28. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
Programming Control
79