Coin #2 Value "Den2 - ALLIANCE HWNLX2SP111CW01 Manual

3.

Coin #2 Value "dEn2"

This option allows the owner to set a specific
numerical value for a coin entered when using the dual
coin drop. For example, the coin value for a dollar
coin would be measured in cents (100). Therefore, the
coin value entered for one dollar coin would be 00100.
If the Vend Price #1 (option 1) is set for "200", and
the Coin Value is set for "00100", the vend price
displayed will decrease by 100 for each dollar coin
entered.
How to Program Coin #2 Value
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES ( ) or the COLD ( )
keypad until "Prog" appears in the display. Press
the START (enter) keypad and "AtS1" will
appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable
options until "dEn2" appears in the display.
4. When "dEn2" appears in the display, press the
START (enter) keypad. There are five digits in
the Coin #2 Value. The fifth digit will appear in
the display and will flash one second on and one
second off. Refer to Figure 6.
NOTE: If the vend price is 10000 or more, the fifth
digit is "1-6". If the vend price is 9999 or less, the
fifth digit is "0".
Figure 6
5. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the value of the
fifth digit.
NOTE: The coin value can be set from 1 to 65,535.
The factory default setting is 100.
202065R6
CHM507R
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off.
NOTE: To go back to the current programmable
option without changing the value, press the
WARM (<) keypad.
7. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the value of the
active digit and the START (enter) keypad to
enter the value of the digit and advance to the
next digit.
8. Press the START (enter) keypad with the last
active digit. The next option, "PLSE", will
appear in the display.
NOTE: To program "PLSE" (Start Pulse Value),
refer to option 4. To program other options, refer to
the appropriate section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
Programming Control
27