Opening The Service Door; Stacked Washers And Dryers, 10 Degree Front Control Washers And Coin Rear Control Washers; Rear Control Washers With Card Reader - ALLIANCE Speed Queen Programming

Stacked Washers and Dryers, 10
Degree Front Control Washers and
Coin Rear Control Washers
Manual programming requires the user to open and close the
service door. Opening and closing the service door trips a switch
allowing access to various programming options, diagnostics, and
audit capabilities. On coin models, the coin vault switch must be
closed to enter Manual Mode.
The service door is located in the control panel on the Stacked
Washer and Dryers and Front Control Washers. On Rear Control
Washers, the service door is located on the top of the meter case.
Refer to Figure 16 .
After opening and closing the service door, the programmer has
4.25 minutes to begin programming. If a keypad has not been
pressed in that time, the control will revert back to the Ready
Mode. Refer to Figure 16 .
NOTE: If the Break-In Alarm option is enabled, it must
be turned off or disabled by pressing the two program-
med keys before opening service door. For more infor-
mation on using the Break-In Alarm, refer to the exter-
nal device or network software instructions.

Rear Control Washers with Card Reader

Manual programming requires the user to remove the control
panel and unplug the bullet connector located between the
"white/black" and "red/blue" wires. This will allow the user to
access various programming options, diagnostics, and audit capa-
bilities. Refer to Figure 16 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT

Opening the Service Door

23
Opening the Service Door
Part No. 806526ENR2