Segger J-Link User Manual page 282

282
Parameter
Tsh
Thh
Tsl
Thl
Table 10.8: Clock frequency
The diagram below shows the TRACECLK frequencies and the setup and hold timing
of the trace signals with respect to TRACECLK.
Full
TRACECLK
DATA
Half-rate
TRACECLK
Note: J-Trace supports half-rate clocking mode. Data is output on each edge of
the TRACECLK signal and TRACECLK (max) <= 100MHz. For half-rate clocking, the
setup and hold times at the JTAG+Trace connector must be observed.
J-Link / J-Trace (UM08001)
CHAPTER 10
Min.
2.5ns
1.5ns
2.5ns
1.5ns
Tch
Tsh Thh
Max.
- Data setup high
- Data hold high
- Data setup low
- Data hold low
Tperiod
Tcl
Tsl
© 2004-2013 SEGGER Microcontroller GmbH & Co. KG
Target interfaces and adapters
Explanation
Thl