Honda MBX50 Workshop Manual page 134

FRONT WHEEL/SUSPENSION
Install the piston ring on the piston.
Install the frok tube rebound spring and piston.
Install the oil lock piece.
Apply locking agent to the socket bolt threads and
underside on the bolt.
NOTE
"' To tighten the socket bolt, it may be neces­
sary to install the fork spring and tighten
the fork bolt provisionally.
e Do not distort the slider in a vise.
Install the back-up ring.
Install the oil seal into the top of the fork slider.
NOTE
Apply ATF to the oil seal and drive it in
with the fork seal driver.
The oil seal is seated when the groove in the
slider is seen at top of the seal.
Install the set ring and dust seal.
Fill the forks with the specified amount of ATF.
SPECIFIED FLUID: ATF
CAPACITIES: 149.5-154.5 cm
Install the fork spring.
NOTE
I nstal I the spring with the narrow pitch end
facing up.
11-17
(1) 6mm HEX WRENCH
(1) FORK SEAL DRIVER BODY
(4) DRIVER ATTACHMENT
2
(5.3-5.5 oz)
07917-3230000
0774 7-0010700
t
�HONDA
� MBX50· MBX80
(2) (3)
OILSEAL DUSTSEAL
(6) SET RING
(5) BACK-UP
RING