Wheel Bearing Inspection; Wheel Rim Runout - Honda MBX50 Workshop Manual

r:;;;)\
HONDA
� MBXSO· MBXSO

WHEEL BEARING INSPECTION

Check the wheel bearing by placing the wheel on
a truing stand and spinning the wheel by hand.
Replace the bearing with a new one if it is noisy or
shows excessive play.
SERVICE LIMIT: 0.027 mm (0.0010 in)

WHEEL RIM RUNOUT

Check the wheel rim for runout by placing the
wheel in a truing stand. Spin the wheel by hand and
read the rim runout using a dial indicator gauge.
SERVICE LIMIT:
Radial: 2.0 mm (0.08 in)
Axial: 2.0 mm (0.08 in)
NOTE
The COMSTAR TM WHEEL cannot be
repaired and must be replaced with a new one
if the service limits are exceeded.
DISASSSMBL Y
Remove the dust steal, bearing and distance collar.
NOTE
Do not forget to install the rim band when
replacing the tire or tube.
�-- ---------�
(1) RADIAL
( 1)
FRONT WHEEL/SUSPENSION
(2)
- - -11--- ----"- -
P LAY
(3) DISTANCE
COLLAR
(4) OIL SEAL
� @ � I
t � �
(5) S P EEDOMETER
GEARBOX RETAINER
11-10