Handlebar Installation - Honda MBX50 Workshop Manual

HONDA
MBXSO,MBX80
INSTALLATION
Place the handlebar onto the lower holder by
aligning the punch mark with the upper face of the
lower holder.
Place the upper holders on the hndlebar with the
punch marks facing the front.
Tighten the forward bolts first, then tighten the rear
bolts.
TORQUE: 8-12 N.m (0.8-1.2 kg-m, 6-9 ft-lb)
Install the front master cylinder with the "N'
mark facing up.
Align the end of the holder with the handlebar
puch mark.
Tighten the upper bolt first, then the lower.
TORQUE: 10-14 N.m (1.0-1.4 kg-m, 7-9 ft-lb)
Apply grease to the throttle grip sliding surface.
Align the locating pin on the throttle grip housing
with the hole in the handlebar and install the
throttle grip.
Connect the clutch cable.
Align the locating pin on the left handlebar switch
with the hole in the handlebar and install the
switch.
Tighten the upper nut first, then tighten the lower
nut.
Route the switch wires (Page 1-7).
Connect the switch wires.
Install the head I ight (Page 11-5).
(1) PUNCH MARK
(2) PUNCH MARK
(1) LOCATING PIN
(3) "N' MARK
(2) PUNCH
MARK
(1) HOLE
FRONT WHEEL/SUSPENSION
(3) UPPER HOLDER
(4) HOLE
11-8