Host Licensing - GE CARESCAPE Monitor B850 Technical Manual

Problem
Unable to read from or write
to the USB memory stick
Barcode scanner cannot read
the barcode
Unable to launch iPanel
software
The wrong character is
displayed when a key is
pressed on the keyboard
The wrong software
application is displayed on
the patient monitor
Unable to perform a function
or a feature is not available
The user interface is
displayed in the wrong
language
Unable to view a certain
feature although the license
is enabled
Unable to upload a license
file
2040384-004D
Possible cause
The patient monitor does not support USB
memory sticks.
The barcode scanner is bad.
The barcode is not configured properly (e.g.,
length vs. character-delimited).
iPanel software is not licensed.
IX Network is not connected to the patient
monitor.
The network connection is bad.
The Citrix server is down.
The patient monitor is not configured
properly.
The keyboard is bad.
The keyboard locale is not configured
properly.
The wrong software application is activated
for the device.
A license has not been purchased for the
feature.
The trial license has expired for the
feature.
The license is not installed properly.
The language is not configured properly.
A software package is active that does
not have that feature (e.g., OR has fewer
features than ICU).
The active mode does not have that
feature.
The license file is corrupted.
The license file is for a patient monitor
with a different serial number.
CARESCAPE Monitor B850
Action
Log onto Webmin > Configuration > Admit Settings
> Barcode Settings. Refer to
page 4-14.
Log onto Webmin > Configuration > Citrix. Refer to
"Citrix" on page 4-13.
Replace the keyboard.
Log onto Webmin > Configuration > Language.
Refer to "Language" on page 4-21.
1. To view the software package that is currently
activated, log onto Webmin > Configuration >
Licenses > Host Licensing.
2. Make sure that the desired software application is
displayed under Currently Active Software
Package.
3. If you need to activate a different software package,
access Configuration > Licenses > Software
Package.
4. Select the correct option and select Activate.
Refer to "Licenses" on page 4-11.
Log onto Webmin > Configuration > Language and
select the correct language. Refer to
page 4-21.
1. Log onto Webmin > Configuration > Licenses >
Software Package.
2. Select the correct option and select Activate.
Log onto Webmin > Configuration > Licenses.
If you have printed license information, select
Software Package and Host Licensing.
If you have a license file, select Upload License.
"Barcode settings" on
"Language" on
8-13