GE CARESCAPE Monitor B850 Technical Manual page 69

Control
4-26
Item
Enterprise URL If required, designate the address
of the GE backoffice servers
required to communicate with the
Remote Service Agent.
Enterprise Tunnel If required, designate the address
URL of the GE backoffice servers
required to communicate with the
tunneling agent.
Protocol Identifies the protocol used to
communicate with the enterprise
servers.
5. Select Save.
The changes will take effect immediately.
After the server has been configured for remote serviceability, the remote service
agent must be enabled for use.
NOTE
Be sure that you have read and understood all associated InSite 2.0
documentation, including
Service, you are enabling supported Remote Service features for this device.
1. If you have not already done so,
Configuration tab.
2. On the Configuration tab, select Remote Service.
3. On the Sub-Modules for Remote Service menu, select Control.
4. Under Remote Service Control on the Remote Service Control window, enable
or disable the Service Agent by selecting Enable or Disable.
5. Select Save.
The changes will take effect immediately.
CARESCAPE Monitor B850
Remote Service Configuration
Description
"Remote service" on page 4-25. By enabling Remote
"Log into Webmin"
Comments
This address should never
be changed unless explicit
instructions are given to do
so.
This field is read-only and
cannot be changed.
on page 4-4 and select the
2040384-004D