Delete Syslog Host - D-Link DGS-3100 SERIES Cli Manual

Restrictions
Example usage:
To configure a syslog host:

delete syslog host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
remote host. This corresponds to number 16 from the list above.
local1 − Specifies that local use 1 messages are to be sent to the
remote host. This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages are to be sent to the
remote host. This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages are to be sent to the
remote host. This corresponds to number 19 from the list above.
local4 − Specifies that local use 4 messages are to be sent to the
remote host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages are to be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages are to be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages are to be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that
the syslog protocol is to use to send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address of the remote host to
which syslog messages are to be sent.
state [enable | disable] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Only Administrator or operator-level users can issue this command.
DGS3100# config syslog host all severity all facility local0
Success.
DGS3100#
To remove a previously configured syslog host from the Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command removes a previously configured
syslog host from the Switch.
<index 1-4> − The syslog host index id. There are four available
indices, numbered 1 to 4.
all − Specifies that the command applies to all hosts.
Only Administrator or operator-level users can issue this command.
DGS3100# delete syslog host 4
Success.
DGS3100#
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
58