Show Syslog - D-Link DGS-3100 SERIES Cli Manual

show syslog

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current status of the syslog function:
create syslog host
Purpose
Syntax
Description
Parameters
To display the syslog protocol status.
show syslog
The show syslog command displays the syslog status (enabled or
disabled).
None.
None.
DGS3100# show syslog
Syslog Global State: Enabled
DGS3100#
To create a new syslog host.
create syslog host <index 1-4> ipaddress <ipaddr> {severity
[informational | warning | all] | facility [local0 | local1| local2 |
local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>}
The create syslog host command creates a new syslog host.
all − Specifies that the command is to be applied to all hosts.
<index 1-4> − The syslog host index id. There are four available
indices, numbered 1 to 4.
ipaddress <ipaddr> − The IP address of the remote host to which
syslog messages are to be sent.
severity − The message severity level indicator. These are
described in the table below (Bold font indicates that the
corresponding severity level is currently supported on the Switch):
Numerical
Code
0
1
2
3
4
5
6
7
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
54