Config Access_Profile (For Ip) - D-Link DGS-3100 SERIES Cli Manual

Restrictions
Example usage:
To configure a rule for the Ethernet access profile:
DGS3100# config access profile profile_id 1 add access_id 1 ethernet vlan Trinity 802.1p 1
port 1 permit priority 1 replace priority 1
Success.
DGS3100#

config access_profile (for IP)

Purpose
Syntax
Description
Parameters
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
previously in this command, before forwarding it on to the
specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value
before being forwarded by the Switch.
•
replace_dscp <value 0-63> – Specifies a value to be
written to the DSCP field of an incoming packet that meets
the criteria specified in the first part of the command. This
value will over-write the value in the DSCP field of the
packet.
•
rate_limit <value 3500-1000000> – Specifies the rate limit
to limit Rx bandwidth for for the profile being configured.
This rate is implemented using the following equation – 1
value = 64kbit/sec. (ex. If the user selects a rx rate limit of
10 then the ingress rate is 640kbit/sec.) The user many
select a value between 3500- 1000000 or no limit. The
default setting is no limit.
deny – Specifies that packets that do not match the access profile
are not permitted to be forwarded by the Switch and will be filtered.
Only Administrator or operator-level users can issue this command.
To configure the IP access profile on the Switch and to define
specific values for the rules that to be used to by the Switch to
determine if a given packet should be forwarded or filtered. Masks
entered using the create access_profile command will be
combined, using a logical AND operational method, with the values
the Switch finds in the specified frame header fields.
config access_profile profile_id <value 1-15> [add access_id
[auto assign | <value 1-255>] [ip {source_ip <ipaddr> |
destination_ip <ipaddr> | dscp <value 0-63> | [icmp {type <value
0-255> code <value 0-240>} | igmp {type <value 0-255>} | tcp
{src_port <value 0-65535> | dst_port <value 0-65535> | flag <flag
1-24>} | udp {src_port <value 0-65535> | dst_port <value 0-
65535>}]} ports <portlist> [permit {replace_priority <value 0-7> |
replace_dscp <value 0-63> | rate_limit <value 64-1000000>} |
deny]
The config access_profile command defines the rules used by the
Switch to either filter or forward packets based on the IP part of each
packet header.
profile_id <value 1-15> – Specifies the access profile id to be
configured with this command. This value is assigned to the access
profile when it is created with the create access_profile command.
The lower the profile ID, the higher the priority the rule will be given.
add access_id <value 1-240> – Adds an additional rule to the above
172