Locking And Unlocking The Front Panel (Executive Modes); Selecting Front Panel Lock Mode 2 Or Toggling Between Lock Modes 2 And 0 - Extron electronics DXP 44 4K PLUS User Manual

Locking and Unlocking the Front Panel (Executive Modes)

The matrix switchers have three levels of front panel security lock that limit the operation of
the switcher from the front panel:
•
•
•
Basic functions include:
•
•
•
Advanced functions include:
•
•
NOTE: The switcher is shipped from the factory in lock mode 2.

Selecting Front Panel Lock Mode 2 or Toggling between Lock Modes 2 and 0

NOTES:
Toggle the front panel lock on and off by pressing and holding the
buttons simultaneously until the following LEDs blink twice (approximately 3 seconds).
•
•
Press and hold simultaneously.
ENTER
3 seconds
ESC
The LEDs blink twice.
Release the buttons.
Figure 24.
Lock mode 0 — The front panel is completely unlocked. All front panel functions are
available.
NOTE: Opening PCS sets the lock mode to 0.
Lock mode 1 — All changes are locked from the front panel (except for setting lock
mode 2). Some functions can be viewed. When the DXP enters mode 1, the
LEDs blink twice.
Audio
Lock mode 2 — Basic functions are unlocked. Advanced features, except for
switching to lock mode 1, are locked and can only be viewed. When the DXP enters
mode 2, the , , and
Esc Video
Making ties
Saving and recalling presets
Changing lock modes
Setting video and audio output mutes
Setting the rear panel Remote RS 232 port protocol and baud rate
•
If the switcher is in lock mode 0 or 1, this procedure selects mode 2.
• If the switcher is in lock mode 2, this procedure selects mode 0 (unlocks the
switcher).
The Esc, Video, and Audio LEDs blink twice if the DXP is now in lock mode 2.
The Video and Audio LEDs blink twice if the DXP is now in lock mode 0.
ESC
I/O
VIDEO
I/O
AUDIO
Switching between Front Panel Lock Modes 0 and 2
LEDs blink twice. This is the default mode.
Audio
VIDEO
AUDIO
DXP HD 4K PLUS Series • Operation
and
Video
, , and
Enter I/O Esc
25