Mini-Sas H240 Cable Option - HPE ProLiant ML150 Gen9 User Manual

Route the SATA cable through the cable management clips, and connect the opposite end of the
14.
cable to the connector on the system board.
Install the fans (on page 24).
15.
Install the system air baffle (on page 22).
16.
If removed, install the PCI air baffle
17.
Install the access panel (on page 19).
18.
Return the server to an upright position.
19.
Connect each power cord to the server.
20.
Connect each power cord to the power source.
21.
Power up the server (on page 17).
22.
Install and lock the tower bezel
23.

Mini-SAS H240 cable option

To install the component:
Unlock and remove the tower bezel
1.
Power down the server (on page 17).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
4.
Remove the access panel (on page 18).
5.
If installed, remove the PCI air baffle (on page 20).
6.
Remove the system air baffle (on page 22).
7.
Remove the fans (on page 23).
8.
("PCI air baffle option" on page 57).
("Install the tower bezel" on page 18).
("Remove the tower bezel" on page 17).
Hardware options installation 72