Memory Options - HPE ProLiant ML150 Gen9 User Manual

Box 1
o
Install the fans (on page 24).
15.
Install the system air baffle (on page 22).
16.
If removed, install the PCI air baffle
17.
Install the access panel (on page 19).
18.
Return the server to an upright position.
19.
Connect each power cord to the server.
20.
Connect each power cord to the power source.
21.
Power up the server (on page 17).
22.
Install and lock the tower bezel
23.

Memory options

IMPORTANT: This server does not support mixing LRDIMMs or RDIMMs. Attempting to mix
any combination of these DIMMs can cause the server to halt during BIOS initialization.
The memory subsystem in this server can support LRDIMMs and RDIMMs:
•
RDIMMs offer address parity protection.
•
LRDIMMs support higher densities than single- and dual-rank RDIMMs, and higher speeds than
quad-rank RDIMMs. This support enables you to install more high capacity DIMMs, resulting in
higher system capacities and higher bandwidth.
All types are referred to as DIMMs when the information applies to all types. When specified as LRDIMM
or RDIMM, the information applies to that type only. All memory installed in the server must be the same
type.
Memory-processor compatibility information
For the latest memory configuration information, see the product QuickSpecs on the Hewlett Packard
Enterprise website (http://www.hpe.com/info/qs).
DIMM type
•
Intel Xeon E5-2600 v3 processors are optimized for:
("PCI air baffle option" on page 57).
("Install the tower bezel" on page 18).
Hardware options installation 44