Disconnect and remove the existing Mini-SAS cable.
9.
Install the H-Series Host Bus Adapter.
10.
Connect the Mini-SAS cable:
11.
Connect one end of the Mini-SAS cable to the host bus adapter.
a.
Route the Mini-SAS cable through the cable management clips, and then connect the other end
b.
to the drive backplane.
Install the fans (on page 24).
12.
Install the system air baffle (on page 22).
13.
If removed, install the PCI air baffle
14.
Install the access panel (on page 19).
15.
Return the server to an upright position.
16.
Connect each power cord to the server.
17.
Connect each power cord to the power source.
18.
Power up the server (on page 17).
19.
Install and lock the tower bezel
20.
("PCI air baffle
option" on page 57).
("Install the tower
bezel" on page 18).
Hardware options installation 73