Power up the server (on page 17).
24.
Install and lock the tower bezel
25.
Drive options
When adding drives to the server, observe the following general guidelines:
If installing a drive in a server that previously has no drive installed, reboot the server after the new drive
•
installation. This action enables the drive thermal protection feature. This feature applies to all drives
supported in this server.
•
The system automatically sets all device numbers.
If only one drive is used, install it in the bay with the lowest device number.
•
Drives must be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To install the component:
Remove the drive blank.
1.
Prepare the drive.
2.
("Install the tower
bezel" on page 18).
Hardware options installation 39