Advertisement
Security and Locks
Key Coding Construction
Key Usage and Identification
Key is used for ignition and door lock cylinder. Keys are cut on both edges to make them reversible.
Key identification is obtained from five character key code stamped on key code tag. Using this key code, key code
cutting combination can be determined from a code list (available to owners of key cutting equipment from suppliers).
If key codes are not available from records or tags, key code can be obtained from the right hand door lock cylinder (if
lock has not been replaced). Lock cylinders supplied by the factory as service parts are unmarked.
If original key is available, key code cutting combination can be determined by laying key.
Rear End Door Opener System Description
Rear end door opener system consists of rear end door opener switch (1), rear end door opener relay (in BCM), rear
end door lock assembly (2) and BCM (3) (in junction block assembly).
Rear end door opener system is activated by pushing rear end door opener switch after all doors are unlocked by
manual door switch, key cylinder switch or keyless entry transmitter.
When rear end door opener switch pushed rear end door opener relay is ON. Then, BCM releases latch of rear end
door lock assembly from striker and rear end door can be opened.
In addition, in case that rear end door cannot be opened by rear end door opener switch, rear end door can be opened
by emergency lever (4) in rear end door lock assembly.
General Description
Security and Locks:
9F-1
S4RS0A9601001
S4RS0A9601002
I4RS0A960025-
Advertisement
