Advertisement
8) Using new brush, apply sufficient amount of primer
onto glass along glass edge.
NOTE:
• Be sure to refer to maker's instruction for
proper handling and drying time.
• Do not apply primer on outside of ceramic
coated surface.
• Do not touch primer coated surface.
Width applied primer for windshield
"a": 15 mm (0.59 in.)
"a"
1
3
"a"
1. Molding
2. Windshield side garnish clip
3. 32.5 mm (1.28 in.)
9) Apply primer for molding along molding surface all
around.
10) Apply adhesive (1) referring to figure.
NOTE:
• Press glass (2) against fittings surface of
body panel quickly after adhesive (1) is
applied.
• Use of rubber sucker grip is helpful to hold
and carry glass after adhesive (1) is
applied.
• Perform steps 8) to 9) within 10 min. to
ensure sufficient adhesion.
• Be sure to refer to adhesive maker's
instruction for proper handling and drying
time.
• Start from bottom side of glass (2).
• Be careful not to damage primer.
Adhesive amount specifications and position for
windshield
Width "a": Approx. 7 mm (0.27 in.)
Height "b": Approx. 15 mm (0.59 in.)
Position "c": Approx. 11 mm (0.43 in.) for front,
rear and upper sections
Position "d": Approx. 35 mm (1.38 in.) for bottom
section
2
"a"
I4RS0A950003-
11) Holding rubber sucker grips (1), place glass onto
12) Check for water leakage by pouring water over
Glass / Windows / Mirrors:
3
2
"d"
"a"
1
"b"
2
4
3. Molding
4. Windshield glass spacer
5. Windshield side garnish clip
body by aligning mating marks marked in step 3) and
press it.
windshield through hose. If leakage is found, dry
windshield and fill leaky point with adhesive. If water
still leaks even after that, remove glass and start
installation procedure all over again.
9E-5
2
5
2
I4RS0A950004-
I2RH01950050-
Advertisement
