Advertisement
Rear End Door Opener System Symptom Diagnosis
NOTE:
• Use SUZUKI scan tool makes it easy to check whether a faulty condition is on the input side or
output side of BCM. For checking procedure, refer to "Diagnosis Using Output Test Function of
SUZUKI Scan Tool" under "Scan Tool Data: in Section 10B".
• Check each part in the order from the top of the following list.
Condition
Rear end door can not be
opened
Rear End Door Opener System Operation Inspection
1) Unlock all doors by using manual lock switch, keyless entry transmitter, or key cylinder switch.
2) Make sure that latch of rear end door is released from striker when rear end door opener switch is pushed.
If malfunction is found, go to "Rear End Door Opener System Symptom Diagnosis: ".
Front Door Lock Assembly Components
1. Front door latch assembly
: Apply lithium grease 99000-25010 to sliding and rotating parts and spring if any.
2. Outside handle
: Apply lithium grease 99000-25010 to sliding part.
3. Outside handle frame
: Apply lithium grease 99000-25010 to sliding part and spring.
Possible cause
Circuit fuse blown
Rear end door opener switch faulty
Rear end door actuator faulty
Wiring or grounding faulty
BCM faulty
Repair Instructions
6
2
3
7
Security and Locks:
Correction / Reference Item
Replace fuse and check for short circuit.
Check rear end door opener switch referring to
"Rear End Door Opener Switch Inspection: ".
Check rear end door actuator referring to
"Power Door Lock Actuator Inspection: ".
Repair circuit.
Replace after making sure that none of above
parts is faulty.
(a)
4
(b)
1
4. Latch striker
5. Shim
6. Key cylinder
9F-5
S4RS0A9604007
S4RS0A9604008
S4RS0A9606001
5
I4RS0A960002-
7. Inside handle bezel
: 5.0 N m
(0.5 kg-m, 4.0 lb-ft)
: 10 N m
(1.0 kg-m, 7.5 lb-ft)
Advertisement
