Advertisement
9C-13 Instrumentation / Driver Info. / Horn:
Parking Brake Switch Inspection
Check for continuity between parking brake switch
terminal and body ground as shown in figure. If found
defective, replace switch.
Parking brake switch specification
OFF position (parking brake released): No continuity
ON position (parking brake lever pulled up):
Continuity
1
1. Parking brake switch
2. Parking brake lever
Door Switch (Front / Rear Door) Inspection
Remove door switch from body and check switch for
continuity. If found defective, replace switch.
Door switch (front / rear door) specification
OFF position (Door closed): No continuity
ON position (Door open): Continuity
Rear End Door Switch Inspection
S4RS0A9306012
Check for continuity between terminal "a" and "b" shown
in the following.
If check result is not as specified, replace switch.
Rear end door switch specification
Rear end door closed: No continuity
Rear end door opened: Continuity
2
I4RS0A930014-
Outside Air Temperature Sensor Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
S4RS0A9306013
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components: in Section 9K".
3) Disconnect connector from outside air temperature
sensor.
4) Remove outside air temperature sensor (1) from
front bumper member.
I3RH0A930004-
Installation
Reverse removal procedure for installation.
a
b
1
S4RS0A9306014
I4RS0A930015-
S4RS0A9306016
I4RS0A930016-
Advertisement
