Advertisement
DTC Clearance
After repair or replace of malfunction part(s), clear all DTCs by performing the following procedure.
Using SUZUKI Scan Tool
1) Connect SUZUKI scan tool to data link connector in the same manner as when making this connection for DTC
check.
2) Turn ignition switch ON and engine stops.
3) Erase DTC according to instructions displayed on scan tool. Refer to scan tool operator's manual for further
details.
4) After completing the clearance, turn ignition switch off and disconnect scan tool from data link connector.
Without Using SUZUKI Scan Tool
1) Turn ignition switch to OFF position.
2) Perform following Steps a) to d) within 10 seconds after ignition switch is turned ON and engine stops.
a) Turn headlight switch to "SMALL" position.
b) Turn headlight switch to "OFF" position.
c) Repeat Steps a) and b) 3 times.
d) Press and release driver side door switch 4 times.
3) After completing above Steps, confirm that no malfunction DTC is detected.
BCM Power Circuit and Ground Circuit Check
Wiring Diagram
[A]: Junction block assembly connector viewed from harness side
1. BCM
2. Junction block assembly
Body Electrical Control System:
3. Ignition switch
4. Battery
10B-15
S4RS0AA204006
S4RS0AA204007
I4RS0AA20008-
Advertisement
