Advertisement
9F-8 Security and Locks:
Door Key Cylinder Switch Inspection
1) Remove front door trim referring to Step 1) to 3) of
"Front Door Glass Removal and Installation: in
Section 9E"
2) Check for continuity between terminals at each
switch position. If check result is not as specified,
replace door lock assembly.
a
b
c
Terminal
Key Position
LOCK
OFF
UNLOCK
Power Door Lock Actuator Inspection
1) Remove door trim from door panel.
For front door, refer to Step 1) to 3) of "Front Door
Glass Removal and Installation: in Section 9E".
For rear door, refer to Step 1) to 3) of "Rear Door
Glass Removal and Installation: in Section 9E".
For rear end door, refer to Step 1) of "Rear End Door
Assembly Removal and Installation: in Section 9J".
2) Disconnect power door lock actuator coupler.
3) Connect battery positive (+) and negative (–)
terminals to the door lock actuator terminals (a, b, c,
d) as shown in figure.
If it does not operate as specified in the following
table, replace door lock assembly.
S4RS0A9606004
a
b
c
I4RS0A960010-
S4RS0A9606005
[A]
a
b
c
d
Right side switch terminals
Left side switch terminals
Unlock
Lock
Lock
Unlock
[B]
a
b
c
d
Right side switch terminals
Left side switch terminals
Unlock
Lock
Lock
Unlock
[C]
Lock
Unlock
[A]: Front door
[B]: Rear door
[C]: Rear end door
d
b
a
c
a
c
d
b
a
b
a
b
I4RS0A960011-
Advertisement
