Advertisement
10C-14 Immobilizer Control System:
Immobilizer Control Module Removal and
Installation
Removal
1) Disconnect negative (-) cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System: in Section 8B".
3) Remove driver air bag (inflator) module referring to
"Driver Air Bag (Inflator) Module Removal and
Installation: in Section 8B".
4) Remove steering wheel referring to "Steering Wheel
Removal and Installation: in Section 6B".
5) Remove steering column lower and upper covers.
6) Disconnect connector (1) from immobilizer control
module (2).
7) Remove a screw (3) from immobilizer control
module.
8) Remove immobilizer control module from steering
lock assembly.
Special Tool
SUZUKI scan tool
—
This kit includes following
items. 1. Tech 2, 2. PCMCIA
card, 3. DLC cable, 4. SAE
16/19 adapter, 5. Cigarette
cable, 6. DLC loopback
adapter, 7. Battery power
cable, 8. RS232 cable, 9.
RS232 adapter, 10. RS232
loop back connector, 11.
Storage case, 12. Power
supply
/
Repair Instructions
S4RS0AA306005
2
3
1
I4RS0AA30008-
Special Tools and Equipment
Installation
Reverse the removal procedure.
Registration of the Ignition Key
To finish the registration of the ignition key, the
transponder code memorized in the transponder built in
the ignition key has to be registered with ECM. To
register the transponder code with ECM, perform
"Register Ig Key" mode of SUZUKI scan tool referring to
"SUZUKI Tech 2 Operator's Manual".
NOTE:
• A maximum of four transponder codes can
be registered with ECM.
• At an early part of the registration process,
all transponder codes of the ignition keys
in use already registered with ECM are
cleared. Therefore, before starting the
registration, prepare all ignition keys in
use in addition to the new ignition key(s) to
be registered with ECM.
Procedure after ECM Replacement
After ECM is replaced with new one, the transponder
code in the transponder built in the ignition key has to be
registered with ECM. To register transponder code in the
ignition key with ECM, perform "Replace New ECM"
mode of SUZUKI scan tool referring to "SUZUKI Tech 2
Operator's Manual".
NOTE:
A maximum of four transponder codes can
be registered with ECM.
S4RS0AA306002
S4RS0AA306004
S4RS0AA308001
Advertisement
