Advertisement
3) Check turn R circuit
Connect terminal "6" and battery negative (–)
terminal by a jumper wire.
Check right side bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
4) Check Hazard ON circuit
Connect terminal "8" and battery negative (–)
terminal by a jumper wire.
Check all bulbs (1) for flashing cycle.
If check result is not as specified, replace turn signal
and hazard warning relay.
Reference flashing cycle
60 – 120 cycle/minute
1
1
License Lamp Assembly Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove rear bumper. Refer to "Front Bumper and
Rear Bumper Components: in Section 9K"
3) Disconnect coupler (1) from license lamp assembly
(2).
4) Push locking part to arrow direction, and then
remove license lamp assembly (2).
3
2
1
8
7
6
5
4
I4RS0A920016-
3
2
1
8
7
6
5
4
I4RS0A920017-
S4RS0A9206022
1
2
Installation
Reverse removal procedure for installation.
Front Fog Light Assembly Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper. Refer to "Front Bumper and
Rear Bumper Components: in Section 9K".
3) Disconnect couplers (1) from fog light (2).
4) Remove fog light screws (3), and remove front fog
light assembly (2).
3
Installation
Reverse removal procedure for installation nothing the
following:
• After installing, adjust aiming referring to "Front Fog
Light Aiming Adjustment with Screen: ".
Lighting Systems:
9B-10
2
2
I4RS0A920018-
S4RS0A9206016
3
2
1
I4RS0A920019-
Advertisement
