Advertisement
9C-11 Instrumentation / Driver Info. / Horn:
Ignition Switch Inspection
• Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
IG1
ACC
B1
ST
IG2
B2
Terminal
B1
B2
Key
Position
OFF
LOCK
ACC
ON
ON
START
Combination Meter Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove column hole cover (1) pulling it in arrow
direction shown in figure.
3) Remove combination meter cluster panel (1) pulling
it in arrow direction shown in figure.
S4RS0A9306002
K1
K2
ACC
IG1
IG2
ST
K1
K2
I4RS0A930009-
S4RS0A9306003
1
I4RS0A930010-
1
4) Remove screws (1) fastening combination meter.
5) Remove combination meter (2) pulling it arrow
direction as shown.
2
Installation
Reverse removal procedure.
Fuel Level Sensor Removal and Installation
Removal
Remove fuel pump assembly referring to "Fuel Pump
Assembly Removal and Installation: in Section 1G".
Installation
Install fuel pump assembly referring to "Fuel Pump
Assembly Removal and Installation: in Section 1G".
Fuel Level Sensor Inspection
• Check that resistance between terminals "a" and "b"
of fuel level sensor changes with change of float
position.
• Check resistance between terminals "a" and "b" at
each float position in the following.
If the measured value is out of specification, replace
fuel pump.
Fuel level sensor specifications
Float Position
31.0 mm
Full Upper "c"
(1.22 in.)
172.0 mm
Full Lower "d"
(6.77 in.)
I4RS0A930011-
1
I4RS0A930012-
S4RS0A9306004
S4RS0A9306005
Resistance ( )
40
2
280
3
Advertisement
