Advertisement
Installation
Reverse removal procedure noting the following.
• Apply grease to sliding and rotating portions of
window regulator.
: Grease 99000–25010
• Tighten rear door window regulator attaching screws.
Rear door window regulator screw tightening
order
(a)
(b)
Rear End Door Window Components
Rear End Door Glass Removal and Installation
Refer to "Windshield Removal and Installation: " as
removal and installation procedures are basically the
same. However, note the following.
• Observe the following precautions when applying
adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in
height.
• Be careful not to damage primer (3).
• With the position of fastener (4) properly aligned,
install glass (2) on rear end door panel (5).
• Press glass against body quickly after adhesive (1) is
applied.
Adhesive amount specifications and position for
rear end door glass
Height "a": 13 mm (0.51 in.)
Rear Door Window Regulator Inspection
Check the following point:
• Check regulator sliding and rotating parts.
• Check rollers for wear and damage.
1. Rear end door glass
Width "b": 6 mm (0.24 in.)
S4RS0A9506013
Width "c": 14 mm (0.55 in.)
Position "d": 12 mm (0.47 in.) for glass upper
section
Position "d": 16 mm (0.63 in.) for glass bottom
section
Position "d": 32.5 mm (1.28 in.) for glass side
sections
Glass / Windows / Mirrors:
(a)
2. Fastener
9E-11
(b)
I4RS0A950024-
S4RS0A9506010
S4RS0A9506012
I4RS0A950025-
Advertisement
