Download Print this page

Suzuki SWIFT RS415 2017 Service Manual page 1129

Advertisement

Windshield Wiper Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove wiper pivot caps (1) and wiper arm nuts (2),
and remove windshield wiper arms with wiper blades
(3).
1
3
2
3) Remove cowl top garnish referring to "Cowl Top
Components: in Section 9K".
4) Disconnect coupler from windshield wiper motor.
5) Remove bolts (1), and remove windshield wiper
assembly (2).
Installation
1) Install windshield wiper assembly (1), and tighten
bolts to specified torque.
Tightening torque
Windshield wiper bolt (a): 8 N·m (0.8 kg-m, 6.0
lb-ft)
2) Connect coupler to windshield wiper motor.
3) Install cowl top garnish referring to "Cowl Top
S4RS0A9406012
Components: in Section 9K".
4) Install windshield wiper arms with wiper blades (1) to
specified position as shown in figure, and then
tighten windshield wiper nuts to specified torque.
Tightening torque
Windshield wiper arm nut (a): 16 N·m (1.6 kg-m,
11.5 lb-ft)
5) Install wiper pivot caps (2) to windshield wiper arm
3
nuts
I4RS0A940006-
6) Connect negative (–) cable to battery.
Windshield Wiper Motor Inspection
NOTE:
Make sure that battery voltage is 12 V or
more.
1) Disconnect negative (–) cable at battery.
I4RS0A940007-
2) Remove windshield wiper arms with wiper blades
referring to "Windshield Wiper Removal and
Installation: ".
3) Remove cowl top garnish referring to "Cowl Top
Components: in Section 9K".
4) Disconnect coupler from windshield wiper motor.
5) Reinstall windshield wiper arms with wiper blade. For
details, refer to Step 4) of "Installation" in "Windshield
Wiper Removal and Installation: ".
6) Check windshield wiper motor for operation as
follows
• For motor operation in low speed
a. Connect battery positive (+) terminal to
b. Check if wiper arm reciprocation speed is as
I4RS0A940008-
Wipers / Washers:
3
4
2
3
1
(a)
3. Ceramic line
4. Wiper blade center
terminal "1" and its negative (–) terminal to
terminal "5".
specification. If check result is not as
specified, replace motor.
Specification
41 – 51 r/min (rpm)
9D-4
2
1
I4RS0A940009-
S4RS0A9406004

Advertisement

loading