Advertisement
9D-7 Wipers / Washers:
• For automatic stop operation
a. Connect battery positive (+) terminal to
terminal "1" and its negative (–) terminal to
terminal "2" and let the motor turn.
b. Disconnect terminal "2" from battery negative
(–) terminal and let the motor stop.
c. Observe the motor (4) turns once again then
stops at a specified position as shown.
5. Mark
d. Repeat Step a. to c. several times and check
that the motor stops at the specified position
every time.
If check result is not satisfied, replace motor.
Windshield Wiper and Washer Switch Removal
and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove steering column hole cover (1).
3) Remove steering column covers (2).
Turn steering wheel to access steering column cover
rear end screws (3).
3
4) Remove windshield wiper and washer switch (1)
from combination switch assembly (2) and
disconnect its coupler (3).
Installation
Reverse removal procedure.
Windshield Wiper and Washer Switch
Inspection
Windshield Wiper and Washer Switch
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
I4RS0A940020-
S4RS0A9406006
2
1
I4RS0A940021-
1
3
MIST
INT
WASHER ON
LO
HI
1 2 3
Terminal
5
Wiper SW
OFF
INTO
LO
HI
MIST
Terminal
1
Washer SW
ON
OFF
2
I4RS0A940022-
S4RS0A9406007
4 5
6
6
4
3
2
I4RS0A940023-
Advertisement
