Advertisement
9F-12 Security and Locks:
NOTE:
• To prevent theft, be sure to break the
transmitter before discarding it.
• Dispose of the used battery properly
according to applicable rules or
regulations. Do not dispose of lithium
batteries with ordinary household trash.
Programming Transmitter Code
NOTE:
• Three transmitter codes can be registered.
• When a new transmitter code is registered,
the oldest one will be cleared.
If transmitter or BCM (included in junction block
assembly) is replaced with a new one or additional
transmitter(s) is necessary, program transmitter code(s).
1) Confirm that all doors are closed and ignition key is
out of ignition key cylinder
2) Open driver side door.
3) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that.
4) Push and release driver side door switch (1) at 3
times by hand within 20 seconds after removing
ignition key from ignition key cylinder.
5) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that. All doors automatically lock and
unlock once.
With this, registration mode.
6) Push "UNLOCK" button (2) on transmitter (3) within
20 seconds after Step 5). All doors automatically lock
and unlock once.
With this, code registration is completed.
7) If an additional transmitter, needs to be programed
repeat the procedure of Step 1).
S4RS0A9606017
1
2
3
I4RS0A960021-
Keyless Entry Receiver Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Remove grove box referring to Step 6) of "Instrument
Panel Removal and Installation: in Section 9C".
3) Disconnect keyless entry receiver coupler.
4) Remove keyless entry receiver (1) from steering
support member (2).
2
Installation
Reverse removal procedure.
S4RS0A9606021
1
I4RS0A960022-
Advertisement
